Suction Power and Cleaning Performance.
Your New Belt Will (Probably) Look Too Small.Depending on the type of belt your vacuum uses, the new one may look or feel too small.
This is partly because the old belt will have stretched during use, but also because many vacuum belts are held in place through tension..Even so, it’s a good idea to double check that the belt is the correct part for your vacuum’s model if you’re not sure that it fits.. Stretching is most common on flat or round vacuum belts.It’s less common on other types, such as geared (cogged) belts..
Step 5: Replace the Base Plate.Once the brushroll is fitted, double check that everything looks correct by comparing it with the photos you took earlier.
You can also try manually spinning the motor shaft to check that the belt is driving the brush roll.. You can then replace the base plate and any other components that needed to be removed to access the brush roll..
Frequently Asked Questions.Check all the inlets and outlets for any blockages that might have caused the vacuum to overheat.
Clumps of hair are a common culprit!.Check the filters for clogging and clean/replace them if necessary (make sure they are fully dry before putting the filters back inside the vacuum).
Allow the vacuum to cool for around an hour before using it again.. To prevent overheating, avoid overfilling your vacuum cleaner and don’t use it for long periods of time without allowing time for cooling.It’s also important to clean your Shark’s filters at least once per month to avoid clogging..